HTE
Home
SBC
Emulators
Wireless
Software
Services
Pricelists
Info Requests
Documents
NoWire-HTX

HTE NoWire-HTX Wireless Data Repeater

 

The HTE NoWire-HTX Wireless Data Repeater significantly enhances the power of  the HTE NoWire series of wireless data acquisition products.  For those applications where data must be relayed distances larger than 100 feet, the NoWire-HTX acts as an interim receiver and repeater site for your wireless data link.  Capable of receiving transmissions from the NoWire-TX Wireless Data Transmitter Units, the NoWire-HTX Wireless Data Repeater will retransmit any and all data that it receives at a higher power level than the NoWire-TX units are capable of producing.  The NoWire-HTX Repeater transmissions are received by the HTE NoWire-HRX  Digital Data Receiver, which can be co-located with the remainder of your data acquisition firmware.  Since the NoWire-HTX Repeater has an approximate transmission range of 1000 feet (actual range is dependent upon the local building environment), a single Digital Data Receiver can acquire data from an an area up to 72 acres.  There is no limit to the number of NoWire-TX units that can be handled by a single NoWire-HTX Repeater, so in your installation plan you only need to consider the transmission range of  the NoWire-TX units in determining where to place the NoWire-HTX Repeater. Larger data acquisition problems are easily solved by simply adding additional NoWire-HTX units to your system to provide additional signal coverage over your facility.  Microprocessor controlled and fully automated, the HTE NoWire-HTX Wireless Data  Repeater is truly a "set it and forget it" device which can be quickly installed in an electrical closet or other similar location.  If additional security is desired, it can even be stud mounted inside a wall.

 

General Specifications (subject to change without notice)

 

Operating Voltage: 24 VDC to 35 VDC

Current Consumption: Receive: TBDTransmit: TBD

Receiver Type: 315.0 MHz, narrowband, crystal stabilized superheterodyne

Receiver Sensitivity: -102 dBm typical

Receiver Spurious Response: -70 dB typical worst case

Transmitter Type: 27 MHz Band, crystal stabilized, ASK modulation

Transmitter Power: 4 Watts maximum

Spurious Emissions: Better than 60 dB down

Effective Range: Approx. 1000 feet (dependent upon local building environment)

Temperature Range: 0°C to +70°C

Dimensions:  6.4" length, 3.7" width, 1.6" height

Weight:  1 lb.

Click here to download spec sheet

Home  |  Single Board Computers  |  InCircuit Emulators  |  Wireless  |  Software

  Services  |  Pricelists  |  Information Requests  |  Documents