HTE NoWire-RX Wireless Data Receiver Unit The HTE NoWire-RX
Wireless Data Receiver Unit complements the NoWire-TX
Wireless Data Transmitter Unit, and completes the wireless portion of your data acquisition system. Comprised of a sensitive digital data radio receiver, the NoWire-RX utilizes a proprietary
combination of hardware and software to significantly increase the immunity of your wireless link to random noise and signal fading. When placed in a location within the transmission range of one or more NoWire-TX
Units, the NoWire-RX will receive the data packets being sent and convert them to a standard digital output data stream, ready for processing by your firmware. Since each NoWire-TX
Unit has an approximate transmission range of 100 feet (actual range is dependent upon the local building environment), a single NoWire-RX Unit can receive data from a network of NoWire-TX
units covering an area up to approximately 31,000 square feet. There is no limit to the number of NoWire-TX units that can be handled by a single NoWire-RX, so in your installation
plan you only need to consider the transmission range of the NoWire-TX units in determining NoWire-RX placement. Microprocessor controlled and fully automated, the HTE
NoWire-RX Wireless Data Receiver Unit is truly a "set it and forget it" device which can be quickly installed almost anywhere. General Specifications
(subject to change without notice) Operating Voltage: 7 VDC to 30 VDC Current Consumption: TBD Receiver Type:
315.0 MHz, narrowband, crystal stabilized superheterodyne Receiver Sensitivity: -102 dBm typical Receiver Spurious Response: -70 dB typical worst case
Data Output: RS-232/422/485 compatible Temperature Range: 0°C to +70°C Dimensions: TBD Weight: TBD |